Table 50: Port Settings
ValuePort Settings
9600Bits per second
8Data bits
NoneParity
1Stop bits
NoneFlow control
5. In the HyperTerminal window, type AT.
For more information on the AT commands, see the Installation and Upgrade Guide
for Security Devices.
An OK response indicates that the modem can communicate successfully with the
COM port on the management device.
6. To dial the modem that is connected to the console port on the services gateway,
type ATDT remote-modem-number. For example, if the phone number of the modem
connected to the console port on the services gateway is 0019785551234, type ATDT
0019785551234.
The services gateway login prompt appears.
7. Log in as the user root. No password is required at initial connection, but you must
assign a root password before you commit any configuration settings.
Related
Documentation
Connecting to the SRX550 High Memory Services Gateway from the CLI Remotely on
page 133
•
• Configuring the Modem at the SRX550 High Memory ServicesGateway End on page 113
• Connecting the Modem to the Console Port on the SRX550 High Memory Services
Gateway on page 110
Configuring the Modem at the SRX550 High Memory Services Gateway End
Before you can connect a dial-up modem to the console port on the SRX550 High Memory
Services Gateway, you must configure the modem to accept a call on the first ring and
to accept DTR signals. You must also disable flow control on the modem.
NOTE: These instructions use Hayes-compatible modem commands to
configure the modem. If your modem is not Hayes-compatible, refer to the
documentation for your modem and enter equivalent modem commands.
113Copyright © 2016, Juniper Networks, Inc.
Chapter 16: Connecting the SRX550 High Memory Services Gateway to External Devices
To Next Page
Loading...
Need help?
General
