CHAPTER 7
Rack Requirements
•
Rack-Mounting Requirements and Warnings on page 53
•
SRX550 High Memory Services Gateway Rack Size and Strength
Requirements on page 57
•
SRX550 High Memory Services Gateway Spacing of Mounting Bracket and Flange
Holes on page 57
•
Clearance Requirements for Airflow and Hardware Maintenance of the SRX550 High
Memory Services Gateway on page 58
Rack-Mounting Requirements and Warnings
Ensure that the equipment rack into which the services gateway is installed is evenly and
securely supported to avoid hazardous conditions that could result from uneven
mechanical loading.
WARNING: To prevent bodily injury when mounting or servicing the services
gateway in a rack, take the following precautions to ensure that the system
remains stable. The following directives help maintain your safety:
•
The services gateway must be installed in a rack that is secured to the
building structure.
•
The services gateway should be mounted at the bottom of the rack if it is
the only unit in the rack.
•
When mounting the services gateway in a partially filled rack, load the rack
from the bottom to the top with the heaviest component at the bottom of
the rack.
•
If the rack is provided with stabilizing devices, install the stabilizers before
mounting or servicing the services gateway in the rack.
Waarschuwing Om lichamelijk letsel te voorkomen wanneer u dit toestel in
een rek monteert of het daar een servicebeurt geeft, moet u speciale
voorzorgsmaatregelen nemen om ervoor te zorgen dat het toestel stabiel
blijft. De onderstaande richtlijnen worden verstrekt om uw veiligheid te
verzekeren:
53Copyright © 2016, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
