13 WIRING HARNESS, BATTERY 83
B01976-10
–
Position EFI control unit
.
–
Mount battery cover
.
Finishing work
– Mount the seat. ( p. 62)
– Set the clock. ( p. 99)
13.3 Disconnecting the battery
Preparatory work
– Switch off all power consumers and switch off the engine.
– Remove the seat. ( p. 61)
G00800-10
Main work
–
Disconnect the negative (minus) cable
of the battery.
Info
Never operate the motorcycle with a discharged battery or without a battery.
In both cases, electrical components can safety equipment can be dam-
aged. The vehicle is therefore no longer roadworthy.
13.4 Connecting the battery
G00800-10
Main work
–
Reconnect minus cable
.
Finishing work
– Mount the seat. ( p. 62)
– Set the clock. ( p. 99)
13.5 Recharging the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
– Keep batteries out of the reach of children.
– Wear suitable protective clothing and goggles.
– Avoid contact with battery acid and battery gases.
– Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
– In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
Warning
Environmental hazard The battery contains elements that are harmful to the environment.
– Do not discard batteries with the household waste. Dispose of faulty batteries in an environmentally compatible manner.
Give the battery to your authorized KTM dealer or dispose of it at a collection point for used batteries.
To Next Page
Loading...
Need help?
General
