Crane operation
11.5 Crane operation with main boom
11 - 92 3 302 819 en Operating manual
GMK3060
13.12.2018
Raising and
lowering
You can adjust the sensitivity of the control levers to suit the operating conditions;
à Setting the characteristic curves for the control levers, p. 11 - 133.
You can regulate the speed by moving the control lever and changing the engine
speed with the accelerator.
H
The maximum derricking speed will automatically be reduced as the system
length is increased. If you now reduce the working radius (for example, by retract-
ing the telescoping), the derricking speed will automatically be increased again.
If when the main boom is being set down, the symbol (1) is displayed:
• Correct the position of the slewable spotlights until the symbol (1) goes out;
à p. 11 - 134.
You can switch on the high-speed mode for a higher speed;
à p. 11 - 119.
G
Risk of accident due to unexpected crane movements!
If assigned more than one function, check whether the Derricking control lever
function is switched on before you move the control lever for derricking.
This prevents accidents due to unexpected crane movements.
Lowering: Push the control lever to the right – the main boom is lowered.
Raising: Push the control lever to the left – the main boom is raised.
S
Risk of damage to the slewable spotlights!
Make allowances for the position of the slewable spotlights before setting down
the main boom.
This is prevent a collision between the working spotlights and the engine cover.
To Next Page
Loading...
Need help?
General
