Crane operation
11.5 Crane operation with main boom
Operating manual 3 302 819 en 11 - 93
GMK3060
13.12.2018
You can adjust the desired engine speed (idling speed) with button (1);
à p. 10 - 9.
Maximum
derricking speed
The maximum permissible derricking speed is limited automatically depending on
the system length. The scale of the limitation is specified in the supplied Lifting
capacity table.
The current speed reduction is displayed in the start menu;
à p. 9 - 21.
You can limit the maximum telescoping speed in the Power unit speed menu;
à p. 11 - 131.
Re-enabling the
raising function
For RCL override – version A
If the RCL has switched off the raising function due to an overload, you can
re-enable the raising function with button (1). The speed will then be reduced
to 50%.
• Press the (1) button in at the bottom once.
• Use the control lever to raise the main boom.
The status display (2) will flash green.
H
The raising of the main boom will be shut down if the main boom angle is too
great. Then all you can do is set the load down.
s
To Next Page
Loading...
Need help?
General
