6 Vector Control and Applied Functions
Multi-function Compact Inverter 3G3MX2-EV2 User’s Manual (I666-E1)
6-8-2 Functional Limitations in PM Motor Mode
In the PM motor mode, induction motor-related functions and some other functions cannot be used.
Parameters for these unavailable functions are not displayed in the PM mode.
In addition, for some parameters, the default data are changed for use with the PM motor.
This section lists the unavailable parameters, unavailable selection functions, and parameter with
changed default data, in this order.
The following parameters are not available and therefore not displayed on the Digital Operator.
1st Automatic Torque Boost Voltage
Compensation Gain
1st Automatic Torque Boost Slip Com-
pensation Gain
Energy-saving Response/Accuracy
Adjustment
Overcurrent Suppression Selection
Frequency pull-in restart function
Reduced Voltage Startup Selection
Reverse Rotation Prevention Selection
Heavy load/Light Load Selection
Overtorque/Undertorque function
Induction motor parameter
V/f Control With Speed Feedback Slip
Compensation Proportional Gain
V/f Control With Speed Feedback Slip
Compensation Integral Gain
Pulse Train Input Type Selection
Simple Position Control Selection
Creep Speed Moving Amount
Positioning Completion Range Setting
Overspeed Error Detection Level
Speed Deviation Excessive Level
F202 to
F203
A201 to
A296
b213 to
b223
C241
H202 to
H234
To Next Page
Loading...
Need help?
General