Polaris ACE 900 2017 User Manual

4.38
9929422 R02 - 2017-2019 ACE 900 Service Manual
© Copyright Polaris Industries Inc.
PEDAL POSITION SENSOR
OPERATION OVERVIEW
NOTICE
DO NOT attempt to service the PPS. The PPS is a non-
serviceable component and can only be tested using
Digital Wrench®. If the PPS is faulty, the entire throttle
pedal assembly must be replaced.
Mounted to the throttle pedal assembly, the PPS acts as
a pedal position sensor. The PPS provides accelerator
pedal position to the Electronic Control Unit (ECU) to
increase or decrease engine RPM using the Electronic
Throttle Control (ETC). The PPS is the primary input
used to control engine speed during vehicle operation.
LOCATION
The Pedal Position Sensor
q
is located in the drivers
foot control area, mounted on the top of the throttle pedal
assembly.
PPS TEST
The PPS can be tested utilizing Digital Wrench® by
verifying that throttle position readout varies as the pedal
is pressed. Reference the Data Display section and be
sure Throttle Position is displayed. With the ignition key
on for at least 15 seconds and engine not running, the
Throttle Position will read approximately 9.6% when the
pedal is released. With the pedal fully depressed, the
Throttle Position will vary depending on what gear you
have selected.
• High/Neutral/Park/Invalid – 70%.
• Low – 60%
• Reverse – 32%
The Pedal Position Sensor is calibrated to the throttle
pedal. If the PPS is faulty, the throttle pedal assembly
must be replaced.
NOTICE
If the PPS fails, disconnect the battery for 10 minutes
and retest.
PPS REPLACEMENT
NOTICE
The PPS is calibrated to the throttle pedal. If the PPS is
faulty, the throttle pedal assembly must be replaced.
1. Disconnect the PPS harness connection
w
located
on the throttle pedal.
2. Remove the seat and disconnect the negative (-)
battery cable.
FUEL SYSTEM

Polaris ACE 900 2017 Specifications

General

Brand	Polaris
Model	ACE 900 2017
Category	Offroad Vehicle
Language	English