To Next Page

To Previous Page

9929422 R02 - 2017-2019 ACE 900 Service Manual

7.5

FRONT BEARING CARRIER DISASSEMBLY

1. Remove the inner snap ring

2. From the front side of the bearing carrier, tap on the

outer bearing race with a drift punch in the reliefs as

shown.

3. Drive bearing out evenly by tapping on outer race

only. Once bearing is at bottom of casting, support

casting on outer edges so bearing can be removed.

4. Inspect the bearing carrier housing for scratches,

wear or damage. Replace front bearing carrier if

damaged.

FRONT BEARING CARRIER ASSEMBLY

1. Thoroughly clean the front bearing carrier housing

and the outer race on the new bearing. Be sure that

all oil residue has been removed from each surface.

2. Support the bottom of the bearing carrier housing.

CAUTION

Use an arbor and press only on the outer race,

otherwise bearing damage may occur.

3. Apply Loctite

603

™

retaining compound to the outer

circumference of the new bearing

race and

carefully press the new bearing into the bearing

carrier housing.

NOTICE

Use care to not allow any of the Loctite

compound to

get in the bearing.

4. Wipe the housing clean of any excess compound and

install the snap ring

FINAL DRIVE

Polaris ACE 900 2017 User Manual

Questions and Answers: