Canceling Data Encryption
Use the following procedure to cancel the encryption settings when encryption is no longer necessary.
• After completing this procedure on the printer's control panel, turn off the power and restart the
printer to enable the new settings. Restarting can be slow when there is data to be carried over to
the hard disk.
•
When disposing of a printer, completely erase the memory. For details about erasing all of the
memory, see page 94 "Deleting Data on the Hard Disk".
Press the [Menu] key, and then select setting items using the [ ] or [ ] key.
1. Log in as the machine administrator from the printer's control panel.
2. Select [Security Options] Press [OK]
3. Select [Machine Data Encryption] Press [OK]
4. Select [Cancel Encryption] Press [OK]
5. Select the data to be carried over to the hard disk and not be reset. Press [OK]
To carry all of the data over to the hard disk, select [Carry Over All Data].
To carry over only the printer settings data, select [CarryOver FileSys DataOnly].
To reset all of the data, select [Format All Data].
6. Select [OK].
7. Select [Continue].
8. Select [Exit] Press [Menu] twice.
9. Log out.
10. Turn off the main power switch, and then turn the main power switch back on.
For details about turning off the power, see "Turning On/Off the Power", Operating Instructions.
1. Log in as the machine administrator from the control panel.
2. Display the "Cancel Encryption" screen.
[System Settings] [Administrator Tools] [Machine Data Encryption Settings] [Cancel
Encryption]
3. Select the data to be carried over to the hard disk and not be reset.
To carry all of the data over to the hard disk, select [All Data].
4. Preventing Leakage of Information from Printer
92