10. Loaded Font Command Set
Loaded Font Function Set Commands
Name Command Sub-command Where to Look
Load Code Page X'D61B' page 197 "Load Code
Page"
Load Code Page
Control
X'D61A' page 198 "Load Code
Page Control"
Load Font X'D62F' page 200 "Load Font"
Load Font Character
Set Control
X'D619' page 202 "Load Font
Character Set Control"
Load Font Control X'D61F' page 203 "Load Font
Control"
Load Font Index X'D60F' page 208 "Load Font
Index"
Load Code Page
This command assigns each code point of a code page to a specific Graphic Character Global ID
(GCGID). One or more Load Code Page (LCP) commands follow the Load Code Page Control
command.
A sequence of LCP commands are used to transmit the entire code page. This sequence is initiated by
the first LCP command that contains data and terminates with an End command. Entries may be split
across LCP commands on any byte boundary and are restricted in size by the standard IPDS 32767
byte command length limit.
Offset Range Meaning Error Code
0-7 (8 Bytes) GRAPHIC CHARACTER GLOBAL ID
197