Configuration using Web Based Management and Command Line Interface
4.4 The Agent menu
SCALANCE X-300 / X-400
116 Configuration Manual, 10/2014, C79000-G8976-C187-22
Syntax of the Command Line Interface
Table 4- 30 Agent DHCP Configuration - CLI\AGENT\DHCPCONF>
Shows the current DHCP configuration
dhcpmode [mode] Sets the DHCP mode. The possible modes are as fol-
lows:
• MAC
MAC address
• CLID
Client ID
• SYSN
device name
• DEVN
PNIO device name
Administrator only.
clientid [ClientID] Specifies the DHCP client ID. This value is used when
DHCP via client ID is set. The client ID can be freely
Administrator only.
Enables/disables Config File Request (Opt. 66, 67)
Agent Time Configuration
Time-of-day synchronization in the network
The following protocols are available for time synchronization in the network:
● SNTP (Simple Network Time Protocol)
● NTP (Network Time Protocol)
● SIMATIC Time
● PTP (Precision Time Protocol)
Make the general settings in the "Agent Time Configuration" screen.
SNTP and NTP require further settings that you can make with the menu items "SNTP
Client" and "NTP Client".
To Next Page
Loading...
Need help?
General