Configuration using Web Based Management and Command Line Interface
4.5 The Switch menu
SCALANCE X-300 / X-400
180 Configuration Manual, 10/2014, C79000-G8976-C187-22
Load Limits Rates (SCALANCE X-300/X408-2)
Limiting the transfer rate of incoming and outgoing data
The configured load limitation is displayed in this menu (maximum number of frames per
second). The set values are valid per port. You can specify the category of frame for which
the entered limit values will apply. You can configure by clicking on the relevant entry.
Figure 4-73 Load Limits Rates
Displays the slot and the port to which the information relates. You can change the
configuration by clicking on the relevant entry in the "Port" column.
Displays the configured frame types to which the limit values for incoming data relate.
Displays the configured limit values for the transfer rates of the incoming data.
Displays the configured limit values for the transfer rates of the outgoing data.
Note
The limits for the outgoing data always relate to all frames.
To Next Page
Loading...
Need help?
General