Configuration using Web Based Management and Command Line Interface
4.5 The Switch menu
SCALANCE X-300 / X-400
Configuration Manual, 10/2014, C79000-G8976-C187-22
151
Changes the master port of a link aggregation.
Changes the name of a link aggregation.
ports <ID> <option> [ports] Changes the members (ports) of a link aggrega-
tion - except for the master port.
The following options are possible:
• -
The port is not a member of the link aggrega-
tion.
• M
The port is a member of the link aggregation.
Administrator only.
Deletes a link aggregation.
LACP Configuration
Enabling LACP functionality
The LACP (Link Aggregation Control Protocol) handles the selection of the active ports of a
link aggregation. You can enable LACP for every link aggregation.
Figure 4-55 LACP Configuration
Here, you enable LACP.
If LACP is enabled, the ports send corresponding LACP frames. If the partner device returns
LACP frames, the ports of the link aggregation are enabled.
If LACP is disabled, the ports of the link aggregation are enabled immediately.
To Next Page
Loading...
Need help?
General