Configuration using Web Based Management and Command Line Interface
4.5 The Switch menu
SCALANCE X-300 / X-400
174 Configuration Manual, 10/2014, C79000-G8976-C187-22
IGMP Configuration
Specifying the aging time
In this menu, you can configure the aging time for IGMP Configuration. When the time
elapses, entries created by IGMP are deleted from the address table if they are not updated
by a new IGMP packet. This applies to all ports; port-specific configuration is not possible in
this case.
Figure 4-68 IGMP Configuration
IGMP Snooping Aging Time [sec]
Here, you enter a time in seconds for the aging time.
Enable this option if you want the IE switch to send IGMP queries as well.
Syntax of the Command Line Interface
Table 4- 50 IGMP Configuration - CLI\SWITCH\MCAST\IGMP>
igmptime [number] Specifies the IGMP aging time in seconds. Without
parameters, this command displays the IGMP aging
Administrator only.
Displays/sets IGMP Query Enable
To Next Page
Loading...
Need help?
General