Configuration using Web Based Management and Command Line Interface
4.7 The Router menu (SCALANCE X414-3E)
SCALANCE X-300 / X-400
Configuration Manual, 10/2014, C79000-G8976-C187-22
289
Syntax of the Command Line Interface
Table 4- 92 RIPv2 Configuration - CLI\ROUTER\RIP>
Shows the current RIP configuration.
Sets RFC1058 (RIPv1) compatibility.
redistr <E|D> <E|D> <E|D> Enables/disables “redistribute routes”.
• Parameter 1
default routes
• Parameter 2
static routes
• Parameter 3
OSPF routes
Administrator only.
RIPv2 Interfaces
Introduction
The "RIPv2 Interfaces" dialog displays an overview of all IP subnets in which the RIP
protocol is used.
With the "New Entry" button, you can register new subnets for RIP.
Note
Before a subnet can be registered for RIP, it must first be created in the "Router Subnets"
menu.
Figure 4-133 RIPv2 Interfaces
IP address of the RIP-compliant subnet (only identifier for this table). All other subnet
parameters such as the subnet mask can be found in the "Router Subnets" dialog.
To Next Page
Loading...
Need help?
General