Siemens SCALANCE X-400 Configuration Manual

Configuration using Web Based Management and Command Line Interface
4.5 The Switch menu
SCALANCE X-300 / X-400
Configuration Manual, 10/2014, C79000-G8976-C187-22
233
Syntax of the Command Line Interface
Table 4- 75 DHCP Relay Agent Configuration - CLI\SWITCH\RELAGENT>
Command
Description
Comment
info
Shows the current settings of the DHCP relay agent.
-
server <number>
[IP][VLANs]
Specifies the IP address and the VLANs of the
DHCP server <number>.
Administrator only.
Default value: 0.0.0.0
remoteid [IP|MAC]
Specifies the relay agent remote ID
Administrator only.
bcastfwd [E|D] Enables/disables the "Enable Broadcast Forwarding"
function.
Administrator only.
reachchk
[E|D]
Enables/disables the "Check for Server Reachability"
function.
Administrator only.
4.5.19.2
DHCP Relay Agent Port Configuration
DHCP Relay Agent Port Parameters
This page displays the currently configured port-specific parameters of the DHCP relay
agent.
Figure 4-102 DHCP Relay Agent Port Parameters
The three columns of the port table show the following information:
Port
Specifies the slot and port to which the information relates. The name of the link aggregation
is shown here if link aggregations are configured.
DHCP Server Selection
Indicates which DHCP servers are responsible for this port.
Neighborhood Detection
Shows whether or not detection of neighbors is enabled for this port.
Only Neighbors
Shows whether the DHCP relay agent functions only for direct neighbors on this port.

Siemens SCALANCE X-400 Specifications

General

Brand	Siemens
Model	SCALANCE X-400
Category	Switch
Language	English