Siemens SINUMERIK 804D sl Function Manual

Detailed description
2.12 Block descriptions
Power Line Basic PLC Program (P3)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
2-243
2.12.29 FC 26: HPU_MCP Transfer of HPU/HT6 signals to the interface
2.12.29.1 General
Description of functions
With FC HPU_MCP (machine control panel signals of the hand-held programming device),
the following are transferred from the machine control panel (MCP) to the corresponding
signals of the NCK/PLC interface:
• Mode groups
• WCS/MCS switchover
• Traversing keys
• Override
In the basic program (FC 2), FC 27 transmits handwheel selections, modes and other
operation signals from the operator panel or MMC to the NCK/PLC interface in such a way
as to allow the modes to be selected from the machine control panel or the operator panel.
Transfer of MMC signals to the interface can be deactivated by setting the value of the
parameter "MMCToIF" to "FALSE" in FB 1 (DB 7).
The following specifications apply to the feed override, axis travel keys and INC keys
depending on the active mode or on the coordinate system selected:
• Feed override:
– The feed override is transferred to the interface of the selected channel and to the
interface of the axes.
– The feed override signals are transferred in addition to interface byte "Rapid traverse"
override (DBB 5) to the NC channel if MMC signal "Feed override for rapid traverse
effective" is set (exception: Switch setting "Zero"). "Rapid traverse override effective" is
also set with this MMC signal.
Machine functions for INC and axis travel keys:
– When the MCS is selected, the signals are transferred to the interface of the selected
machine axis (for 6 axes).
– When the WCS is selected, the signals of the first three axes are transferred to the Geo
axis interface of the parameterized channel. The remaining three axes are transferred to
the interface of the selected machine axis.
The handwheel selection signals of the MMC are decoded and activated in the associated
(machine) axis interface or geo axis interface of the relevant handwheel (only if FB 1
parameter "HWheelMMC := TRUE").
The LEDs on the machine control panel derived from the selections in the acknowledgment.
Feedrate and spindle Start/Stop are not transferred to the interface, but output modally as a
"FeedHold" or "SpindleHold" signal. The user can link these signals to other signals leading
to a feed or spindle stop (this can be implemented, e.g., using the appropriate input signals
in FC 10: AL_MSG). The associated LEDs are activated at the same time.

Siemens SINUMERIK 804D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 804D sl
Category	Control Systems
Language	English