Chapter
379
Cross-Point Setup
Creating a Cross-Point
Assign Table
You can create a main table (Main) and up to 14 other
tables (Table1 to Table14) as cross-point assign tables.
You can configure the video signal and key signal
combinat
ions in the main table.
Creating the Main Table
You can assign a signal pair consisting of a video signal
and a key signal to each cross-point button number.
You can also assign t
he same signals to multiple button
numbers to duplicate the assignment.
1
Open the Home > Setup > Xpt Assign > Main, V/K
Pair Assign menu (19102.21).
The V/K pair number (cross-point button number),
video sign
al source name and number, and key signal
source name and number are displayed.
2
Select the target button number to set.
To select and set multiple button numbers, place a
c
heck mark beside the target button numbers to set.
To select and set all button
numbers, place a check
mark in the Select All checkbox.
3
Press the [Edit] button.
To set the video signal, press the [Edit] button for
[Video].
To set the key signal, press the [Edit] button for
[Key]
.
The [Select Source] window appears.
4
Set the button for the source signal to assign to the on
state.
Select a tab to change the type of signal to display.
[Input] tab: In
put signals
[B/W/COLBKG] tab: Bl
ack, white, and color
background signals
[DME/FM/CLIP] tab: DME
monitor, frame
memory, and clip player output signals
[PP/ME Out] tab: Swit
cher bank output signals
Input signals 45 to 48 cannot be used.
5
Press [OK].
When a signal is not assigned
On the [B/W/COLBKG] tab of the [Select Source]
window,
select the [N/A] button.
The signal will not be switched even when the c
ross-point
button is pressed.
To delete a button number setting
Select the target button number to delete and press the
[De
lete] button.
The settings for all the button nu
mbers not deleted move
up in sequence.
To insert a button number setting
Select the button number at the in
sertion position and
press [Insert].
A button number is inserted and the settings of all other
b
uttons are shifted by one.
To return to the initial settings
Press the [Default Recall] button, check the message, then
press [OK].
Creating Tables 1 to 14
You can assign the V/K pair signals configured in the
main table to cross-point button numbers.
1
Open the Home > Setup > Xpt Assign > Table Button
Assign menu (19102.31).
2
Display the target table to set.
Select a tab to change the table
(Table1 to Table14) to
display.
Note
To Next Page
Loading...
Need help?
General
