6-3 POWER UNIT
POWER UNIT
REMOVAL
Before removing power unit :
• Drain engine oil.
• Remove intake manifold assembly. (See page 6-1)
Remove two bolts and low pressure fuel pump
1.
Disconnect ignition coil connectors.
Remove the bolt securing the ignition coil
2.
Remove all ignition coils
2 and spark plugs.
Disconnect CMP sensor connector
3.
Remove the twelve (12) cylinder head cover bolts, and then
remove cylinder head cover
4.
Remove starter motor. (See page 4-11)
Remove flywheel. (See page 3-48)
09930-48720 : Flywheel holder
09930-39411 : Flywheel remover
09930-39420 : Flywheel remover bolt
z
To Next Page
Loading...
