POWER TRIM AND TILT 8-2
SERVICE PROCEDURE
OIL LEVEL
To check the oil level :
1. The motor should be raised to a full-tilt position.
2. Lower the manual tilt lock lever 1.
3. Remove the oil filler plug 2.
4. If oil can be seen at filler plug level, the unit is full.
5. If oil level is low, refill with the recommended oil.
Recommended oil :
Dexron automatic transmission fluid or equivalent
B
To ensure consistent pump operation, do not mix dif-
ferent types of oil.
6. Reinstall oil filler plug.
AIR BLEEDING
1. Open manual release valve before performing air bleeding.
2. Manually raise and lower engine (full up to full down) 5-6
times.
3. Check oil level, topping off if necessary.
4. Reinstall oil filler plug.
To Next Page
Loading...
