Suzuki DF 50 Service Manual

PERIODIC MAINTENANCE 2-18
ANODES AND BONDING WIRES
Inspect every 50 hours (3 months).
ANODES
If 2/3 of the zinc anode has corroded away, replace the anode.
B
Never paint the anode.
NOTE:
The anode securing bolt should be covered with Suzuki Sili-
cone Seal.
99000-31120 : Suzuki Silicone Seal
k
BONDING WIRES
• If breakage or other damage is found on the wire, replace the
wire.
• If rust, corrosion, or other damage is found on terminal, clean
with cleaning solvent or replace the wire.
NOTE:
The insulation washer must be installed between the terminal
and the motor body.
Anode
k
Insulation washer
Bonding wire terminal

Suzuki DF 50 Specifications

General

Engine Type	4-Stroke
Cylinders	3
Displacement	941 cc
Starting System	Electric
Steering	Remote
Engine Type Detail	DOHC 12-Valve
Maximum Output	50 HP
Ignition System	Digital CDI
Alternator	12V 19A
Gear Ratio	2.27:1
Exhaust	Through Prop Hub Exhaust
Trim Method	Power Trim and Tilt
Max Power	50 HP
Alternator Output	12V 19A
Fuel Delivery System	Sequential Multi Point Electronic Fuel Injection
Full Throttle Operating Range	5, 300 - 6, 300 rpm
Engine Oil Capacity	2.7 L
Full Throttle RPM Range	5300 - 6300 RPM
Oil Capacity	2.7 L
Bore x Stroke	72.5 x 76.0 mm (2.85 x 2.99 in.)