Suzuki DF 50 Service Manual

9-7 LOWER UNIT
INSPECTION
NOTE:
If any component is worn excessively, cracked, defective or
damaged in any way, it must be replaced.
NOTE:
Thoroughly wash all metal components with cleaning solvent
and dry with compressed air.
A
Wear safety grasses when using compressed air.
PROPELLER
• Inspect the propeller for bent, chipped or broken blades.
Replace or repair propeller if in damaged condition.
• Inspect propeller bush splines. Replace or repair propeller if
splines are worn or damaged.
• Inspect propeller bush for deterioration or slipping.
Replace if necessary.
GEARCASE
• Inspect the gearcase. Replace if cracked or damaged.
• Visually check the pinion bearing. Replace if pitted, noisy or
rough.
NOTE:
If removal and replacement are required, see the “PINION
BEARING” section on page 9-5.

Suzuki DF 50 Specifications

General

Engine Type	4-Stroke
Cylinders	3
Displacement	941 cc
Starting System	Electric
Steering	Remote
Engine Type Detail	DOHC 12-Valve
Maximum Output	50 HP
Ignition System	Digital CDI
Alternator	12V 19A
Gear Ratio	2.27:1
Exhaust	Through Prop Hub Exhaust
Trim Method	Power Trim and Tilt
Max Power	50 HP
Alternator Output	12V 19A
Fuel Delivery System	Sequential Multi Point Electronic Fuel Injection
Full Throttle Operating Range	5, 300 - 6, 300 rpm
Engine Oil Capacity	2.7 L
Full Throttle RPM Range	5300 - 6300 RPM
Oil Capacity	2.7 L
Bore x Stroke	72.5 x 76.0 mm (2.85 x 2.99 in.)