Suzuki DF 50 Service Manual

9-9 LOWER UNIT
Replacing propeller shaft oil seal
1. Extract the seals with oil seal remover.
09913-50121 : Oil seal remover
2. Apply Water Resistant Grease to the inner circumference of
the housing.
SHIFT ROD AND SHIFT CAM
• Inspect the “stepped” surfaces of the shift cam.
Replace if chipped, damaged or excessively worn.
• Inspect shift rod guide. Replace if pitted, stiff or corroded.
• Inspect O-ring. Replace if nicked, cut or torn.
• Inspect shift rod boot. Replace if cracked or damaged.
3. Using an oil seal installer, drive the two oil seals (one at a
time ) into the propeller shaft bearing housing.
The lipped portion of the seal must face towards the pro-
peller.
Apply Water Resistant Grease to the seal lips.
WATER PUMP AND RELATED ITEMS
• Inspect impeller. Replace if vanes are cut, torn or worn.
• Inspect pump case. Replace if cracked, distorted or corroded.
• Inspect under panel. Replace if cracked, distorted or corroded.
z

Suzuki DF 50 Specifications

General

Engine Type	4-Stroke
Cylinders	3
Displacement	941 cc
Starting System	Electric
Steering	Remote
Engine Type Detail	DOHC 12-Valve
Maximum Output	50 HP
Ignition System	Digital CDI
Alternator	12V 19A
Gear Ratio	2.27:1
Exhaust	Through Prop Hub Exhaust
Trim Method	Power Trim and Tilt
Max Power	50 HP
Alternator Output	12V 19A
Fuel Delivery System	Sequential Multi Point Electronic Fuel Injection
Full Throttle Operating Range	5, 300 - 6, 300 rpm
Engine Oil Capacity	2.7 L
Full Throttle RPM Range	5300 - 6300 RPM
Oil Capacity	2.7 L
Bore x Stroke	72.5 x 76.0 mm (2.85 x 2.99 in.)