Suzuki DL1000 Service Manual

5-16 COOLING AND LUBRICATION SYSTEM
• Apply a small quantity of the SUZUKI SUPER GREASE “A” to
the oil seal lip.
) 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the new mechanical seal using a suitable size socket
wrench.
NOTE:
On the new mechanical seal, the sealer
A has been applied.
• Install the new bearing using the special tool.
& 09913-70210: Bearing installer set
NOTE:
The stamped mark on the bearing faces crankcase side.
• Apply grease to the impeller shaft.
) 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the rubber seal
1 into the impeller.
• After wiping off the oily or greasy matter from the mechanical
seal ring, install it into the impeller.
– continued on next page –

Suzuki DL1000 Specifications

General

Displacement	996cc
Compression Ratio	11.3:1
Final Drive	Chain
Starter	Electric
Bore x Stroke	98.0mm x 66.0mm
Transmission	6-speed
Rear Suspension	Link type, coil spring, oil damped
Front Brakes	Dual hydraulic disc
Rear Brakes	Single hydraulic disc
Fuel Tank Capacity	22.0 L (5.8 US gal)
Ground Clearance	165 mm (6.5 in)
Ignition	Electronic
Fuel System	Electronic Fuel Injection