Suzuki DL1000 Service Manual

COOLING AND LUBRICATION SYSTEM 5-17
NOTE:
The paint marked side
A of the mechanical seal ring faces the
impeller.
• Install the impeller to the water pump body.
• Fix the impeller shaft with the snap ring securely.
• Install a new O-ring
1.
!
NOTE:
Apply engine coolant to the O-ring
1.
• Set the impeller shaft end to the cam drive idle shaft.
(#3-90)
• Connect the water hoses and crankcase breather hose.
• Install the right footrest.
• Pour engine coolant. (#2-17)
• Pour engine oil. (#2-12)
• Install the engine under cover.
Use a new O-ring to prevent engine coolant leakage.

Suzuki DL1000 Specifications

General

Displacement	996cc
Compression Ratio	11.3:1
Final Drive	Chain
Starter	Electric
Bore x Stroke	98.0mm x 66.0mm
Transmission	6-speed
Rear Suspension	Link type, coil spring, oil damped
Front Brakes	Dual hydraulic disc
Rear Brakes	Single hydraulic disc
Fuel Tank Capacity	22.0 L (5.8 US gal)
Ground Clearance	165 mm (6.5 in)
Ignition	Electronic
Fuel System	Electronic Fuel Injection