149
Setup
The printer utilizes two (2) sensing methods to accommodate a wide range of media
• Center area transmissive sensing for continuous media and gap/web label media.
• Full-width reflective sensing for print format (length) using black marks, black
lines, notches or holes.
Setting Media Sensing by Media type
• For web/gap media, the printer senses the differences between the label and the
liner to determine the print format length.
•
For continuous roll media, the printer only senses the media’s characteristics.
The print format’s length is set by programming (driver or software) or the last
stored form’s length.
•
For black mark media, the printer senses the beginning of the mark and the dis-
tance to the start of the next black mark to measure the print format length.
•
For other common media and setting variations, see one of the following:
• Using the Label Dispenser Option after you have loaded media using this
procedure.
• See Printing on Fan-Fold Media