85
Printer Configuration Menus
LABEL LENGTH MAX
Description: This setting controls the distance the printer utilities, like SmartCal, use to
automatically detect labels (black mark, notch or gap/web). If the printer does not detect
and calibrate the label, the printer assumes that continuous media is loaded.
Set the value to the longest label used with the printer plus 1.0 inch (25.4 mm) greater than
the maximum length label. Ideally, use a value 2 times the max. label length plus an inch.
Accepted values: 1-39(inches),39default
Related ZPL command(s): ^ML
(^LL,^PW)
SGD command used: ezpl.label_length_max
Print Server web page: View and Modify Printer Settings
> Media Setup >
Maximum Length
SETTINGS
—
DARKNESS
—
PRINT SPEED
—
MEDIA TYPE
—
PRINT METHOD
—
TEAR OFF
—
PRINT WIDTH
—
PRINT MODE
—
LABEL TOP
—
LEFT POSITION
—
REPRINT MODE
—
LABEL LENGTH MAX
—
LANGUAGE
2
1
3
1 — Label length (including inter-label gap)
2 — Inter-label gap
3 — Label length (
1) plus an inch (25.4mm)