246
Maintenance
Media Path Cleaning
Use a cleaning swab and/or a lint free cloth to remove debris, dust or crust that has built-
up on the holders, guides and media path surfaces. Lightly moisten the swab or cloth with
99% solution medical-grade alcohol. For hard to clean areas, use extra alcohol on a
cleaning swab to soak the debris to break up any adhesive that may have accumulated on
surfaces in the media compartment.
Do not clean the printhead, sensors, or platen as part of this process.
Lower Half of ZD60/ZD420 Printers
The lower half of these printers these printers get cleaned the same.
1. Wipe the inside surfaces of the roll holders and the underside of the media guides
with a cleaning swabs and wipes.
2. Wipe the movable sensor slide channel (but not sensor). Move the sensor to get to all
areas.
3. Wait one minute before closing the printer. Discard used cleaning supplies.
Media Guides
Media Roll Holders
Don’t Clean Sensor