11.67
•
Install oil filter with oil filter wrench,
BMWNo.114650.
•
Insert and tighten oil drain plug with a new seal.
X Tightening torque:
Oil filter (sealing face lightly oiled) ................ 11 Nm
Oil drain plug................................................ 32 Nm
•
Install spark plugs with spark plug socket
wrench, BMW No. 12 3 510.
X Tightening torque:
Spark plug NGK BKR 7 EKC........................ 25 Nm
11 00 050
Installing engine
L Note:
Integral ABS After switching on the ignition, always
wait for the BMW Integral ABS to complete its self-
diagnosis. Do not operate the brake lever until the
self-diagnosis routine has been completed.
•
Switch on the ignition.
•
Without starting the engine, fully open the throttle
once or twice so that the Motronic control unit
can register the throttle-valve positions.
L Note:
Disconnecting the battery deletes all entries (e.g.
faults, settings) stored in the Motronic control unit’s
memory.
Loss of settings can temporarily impair the operat-
ing characteristics when the engine is restarted.
•
Installation is the reverse of the removal proce-
dure (
a 11.16).
•
Check and, if necessary, adjust idling speed,
synchronisation, throttle flaps (
a 00.59).
11 4 650
RS110950
12 3 510
RS000010
To Next Page
Loading...
Need help?
General
