33.18
33 10 050 Installing rear-wheel drive unit
L Note:
Do not lay oil-filled rear-wheel drive on its side prior
to installation, as this will cause oil to escape when
the motorcycle is on the road (suction effect).
•
Coat splines of sliding element (arrow) with
Staburags NBU 30 PTM.
•
Install the inner races of the needle roller bear-
ings with a small quantity of
Staburags NBU 30 PTM.
•
Place rear-wheel drive with flexible gaiter in posi-
tion and introduce sliding element into universal
shaft.
•
Install fixed-bearing stud bolt (1) with Loctite.
e Attention:
Make sure that the inner race never presses against
the ends of the needles.
L Note:
Use an acetone-based cleaning agent such as
Loctite quick cleaner 706
Loctite Order No. 70636-AC
•
Screw in floating bearing stud (2) with Loctite.
e Attention:
When tightening threaded fasteners coated with
Loctite 2701, always apply final torque without de-
lay.
Allow at least 3 hours for the Loctite to cure.
•
Tighten fixed bearing stud (1).
•
Tighten floating bearing stud (2).
•
Tighten locknut (3).
•
Tighten clamping strap (4) on gaiter.
•
Engage strut (5).
•
If necessary, fill with oil.
•
Install the rear wheel.
R22330010
2
1
3
4
5
6
To Next Page
Loading...
Need help?
General
