BMW R 1150 RT Repair Manual

32.15
32 73 056 Removing and installing
Bowden-cable divider, Bowden
cable for throttle actuation and
starting-speed increase
•
Remove side panels.
•
Remove fuel tank.
•
Remove actuating cable for starting-speed in-
crease.
•
Disengage cable (A) from grip unit.
•
Remove Bowden-cable shroud from fitting for
throttle actuation.
•
Release cable (B) and disengage it from grip unit.
•
Disengage throttle cables from right and left
throttle flap stubs.
•
Remove cable ties securing Bowden cables.
•
Release the plug for the fuel pump from the
frame.
•
Press down tab (1) and pull cable divider (2) out
of its retainer in direction indicated by arrow.
•
Installation is the reverse of the removal proce-
dure.
•
Adjust Bowden cables (a 00.59).
B
A
B
A
R22320050
1
2

BMW R 1150 RT Specifications

General

Displacement	1130 cc
Transmission	5-speed
Final Drive	Shaft
Bore x Stroke	101 mm x 70.5 mm
Compression Ratio	10.3:1
ABS	Optional
Engine Type	Air/oil-cooled, four-stroke, Boxer twin
Power	95 hp at 7, 250 rpm
Torque	100 Nm at 5, 500 rpm
Dry Weight	259 kg
Front Suspension	Telelever
Rear Suspension	Paralever
Front Brakes	Dual disc
Rear Brakes	Single disc
Wheelbase	1485 mm (58.5 in)