00.61
•
Use the adjusting screw (arrow) to adjust play of
the choke cable to zero.
•
Push the rubber cap into position over the ad-
justing screw.
•
Move the handlebars all the way from left to right
and check the settings. Make sure that engine
speed does not vary when the handlebars are
moved in this way.
•
Repeatedly open the throttle gradually and in-
crease engine speed from idle to approximately
n = 2,500 rpm to check throttle-valve synchroni-
sation. (Readings shown by Synchro tester must
increase and decrease together). If necessary,
correct by turning the adjusting screws of the
throttle-valve Bowden cable.
L Note:
Make sure that when the throttle grip is released
both throttle valves return to their fully closed posi-
tions.
•
Tighten the locknuts and recheck carburettor
balance.
•
Seal off the vacuum bores.
•
Assembly is the reverse of the disassembly
procedure.
Final inspection with road safety
and functional check
(Inspections I, II, III and IV)
Road safety check
•
Check wheels and tyres.
•
Check/correct tyre pressures.
•
Wait at least 10 minutes after heating the engine
to operating temperature in the trial run/road test
before checking/correcting engine oil level.
Tyre pressures:
one-up ................................. front 2.2 bar (31.9 psi)
........................................... rear 2.5 bar (36.26 psi)
two-up ............................... front 2.5 bar (36.26 psi)
........................................... rear 2.9 bar (42.06 psi)
two-up + luggage............... front 2.5 bar (36.26 psi)
........................................... rear 2.9 bar (42.06 psi)
Roadworthiness check
•
Lights
•
Telltale/warning lights
•
Horn
•
Instruments
•
Special equipment
•
Clutch
•
Gear shift
•
Steering
•
Footbrake and handbrake, Integral ABS
•
If necessary, take the motorcycle for a test ride.
R22000330
To Next Page
Loading...
Need help?
General
