BMW R 1150 RT Repair Manual

16.9
62 16 Removing and installing
immersed level sensor
e Attention:
Fuel is flammable and a hazard to health.
Observe all applicable safety regulations.
•
Remove fuel tank (a 16.5).
•
Drain fuel tank.
•
Remove fuel filler cap and tank trim panels.
•
Remove fasteners of fuel pump unit (1) and raise
the unit slightly.
•
Disconnect plug (2).
•
Release the hose clips (3) with pliers,
BMWNo.175500, and disconnect hoses.
•
Release immersed level sensor (4) and lift out
complete with hoses.
•
Installation is the reverse of the removal proce-
dure.
L Note:
Note locator (arrow) for hoses on the immersed level
sensor.
e Attention:
Make sure seal (5) and O-rings are in perfect condi-
tion.
After installing, check fuel tank for leaks.
6x
6x
R22160022
1
4
2
3
5

BMW R 1150 RT Specifications

General

Displacement	1130 cc
Transmission	5-speed
Final Drive	Shaft
Bore x Stroke	101 mm x 70.5 mm
Compression Ratio	10.3:1
ABS	Optional
Engine Type	Air/oil-cooled, four-stroke, Boxer twin
Power	95 hp at 7, 250 rpm
Torque	100 Nm at 5, 500 rpm
Dry Weight	259 kg
Front Suspension	Telelever
Rear Suspension	Paralever
Front Brakes	Dual disc
Rear Brakes	Single disc
Wheelbase	1485 mm (58.5 in)