BMW R 1150 RT Repair Manual

34.30
•
Install rear brake pads and brake caliper.
•
Hand-tighten cap of rear wheel-circuit reservoir.
•
Check operation of the brake system with the ig-
nition switched on.
e Attention:
After all the work on the brake system has been
completed, run a bleed test using the
BMW MoDiTeC.
•
Perform bleed test with BMW MoDiTeC.
•
Install fuel tank.
Brake fluid....................................................DOT 4
X Tightening torque:
Bleed screw in rear brake caliper ................... 5 Nm
Brake caliper to rear wheel drive .................. 40 Nm
34 00
Integral ABS
Reading fault memory with
BMW MoDiTeC
•
Remove front and rear seats.
•
Connect the BMW MoDiTeC to the diagnosis
connector.
•
Read out the fault memory.
•
Clear the fault memory if applicable, or perform
all requisite repair work.
34 00
Integral ABS
Performing bleed test with
BMW MoDiTeC
•
Remove front and rear seats.
•
Connect the BMW MoDiTeC to the diagnosis
connector.
d Warning:
When performing maintenance and repair work on
BMW Integral ABS, never pump quickly or
vigorously.
•
Perform bleed test.
•
Perform all requisite repair work.

BMW R 1150 RT Specifications

General

Displacement	1130 cc
Transmission	5-speed
Final Drive	Shaft
Bore x Stroke	101 mm x 70.5 mm
Compression Ratio	10.3:1
ABS	Optional
Engine Type	Air/oil-cooled, four-stroke, Boxer twin
Power	95 hp at 7, 250 rpm
Torque	100 Nm at 5, 500 rpm
Dry Weight	259 kg
Front Suspension	Telelever
Rear Suspension	Paralever
Front Brakes	Dual disc
Rear Brakes	Single disc
Wheelbase	1485 mm (58.5 in)