00.53
•
Correct the brake fluid level.
•
Wipe the rim of the reservoir, the rubber dia-
phragm and the cover to remove brake fluid, and
carefully reassemble the components.
•
Place the motorcycle on its centre stand.
Specified level
not below ......................................................... MIN
e Attention:
After all the work on the brake system has been
completed, run a bleed test using the
BMW MoDiTeC.
•
Perform bleed test with BMW MoDiTeC.
(
a 00.31)
•
Install fuel tank.
Brake fluid....................................................DOT 4
Checking clutch operating fluid
level
(Inspections II and III)
e Attention:
Keep the brake fluid in the clutch operating system
away from painted surfaces on the motorcycle be-
cause brake fluid attacks paint.
•
Place motorcycle on its centre stand.
•
Move the handlebars to the straight-ahead po-
sition.
Specified level with a new clutch liner:
...........................................Half way up sight glass
L Note:
As the clutch lining wears, the fluid level in the res-
ervoir rises.
•
If necessary, remove reservoir cap with insert.
•
Correct the fluid level.
– Mark in reservoir: same as brake circuit.
•
Reinstall the reservoir cap with insert.
•
Tighten the reservoir cap carefully and without
using force.
Brake fluid ...................................................DOT 4
R22000150
R22000190
To Next Page
Loading...
Need help?
General
