BMW R 1150 RT Repair Manual

33.12
33 12 Removing and disassembling
crown wheel
•
Remove housing cover (1) with crown wheel (2)
and bearing (3).
•
Heat housing cover to 100 °C (212 °F) and pull it
off.
•
Force shaft seal (4) out of housing cover with
drift.
•
Clamp crown wheel in vise with protective jaws.
•
Insert thrust block (arrow), BMW No. 00 7 511.
•
Using puller, BMWNo.331830, pull off deep-
groove ball bearing.
•
Insert thrust block, BMW No. 11 0 561.
•
Using puller, BMW No. 00 7 500, pull taper roller
bearing off crown wheel.
•
Turn the housing upside down and heat it until
the outer ring is released and drops out
(max. 100 °C/212 °F).
S330080
1
3
2
w
4
h
100
33 1 830
KR330180
00 7 511
00 7 500
R21330100
11 0 561

BMW R 1150 RT Specifications

General

Displacement	1130 cc
Transmission	5-speed
Final Drive	Shaft
Bore x Stroke	101 mm x 70.5 mm
Compression Ratio	10.3:1
ABS	Optional
Engine Type	Air/oil-cooled, four-stroke, Boxer twin
Power	95 hp at 7, 250 rpm
Torque	100 Nm at 5, 500 rpm
Dry Weight	259 kg
Front Suspension	Telelever
Rear Suspension	Paralever
Front Brakes	Dual disc
Rear Brakes	Single disc
Wheelbase	1485 mm (58.5 in)