BMW R 1150 RT Repair Manual

33.13
33 12 Assembling and installing crown
wheel
•
Heat the housing to 80 °C (176 °F).
•
Insert the outer race in the bearing seat with drift,
BMWNo.234670, and handle,
BMWNo.005500.
•
Check that outer race is correctly seated by tap-
ping it gently.
L Note:
If new parts are installed (e.g. taper roller bearing),
check tooth backlash and adjust if necessary.
•
Place original spacer (1) or spacer measuring
2.25 mm (0.0885 in) in thickness on crown wheel
(for provisional backlash).
L Note:
Install spacer with bevel on inside diameter toward
crown wheel.
•
Heat taper roller bearing (2) to 80 °C (176 °F) and
push it on.
•
Install crown wheel (3).
•
Heat grooved ball bearing (4) to 80 °C (176 °F)
and place it in position.
R22330040
23 4 670
00 5 500
h
80
w
S330100
h
80
h
80
4
3
1
2
w
w

BMW R 1150 RT Specifications

General

Displacement	1130 cc
Transmission	5-speed
Final Drive	Shaft
Bore x Stroke	101 mm x 70.5 mm
Compression Ratio	10.3:1
ABS	Optional
Engine Type	Air/oil-cooled, four-stroke, Boxer twin
Power	95 hp at 7, 250 rpm
Torque	100 Nm at 5, 500 rpm
Dry Weight	259 kg
Front Suspension	Telelever
Rear Suspension	Paralever
Front Brakes	Dual disc
Rear Brakes	Single disc
Wheelbase	1485 mm (58.5 in)