00.38
Checking brake fluid level
(Inspections II and III)
L Note:
The brake fluid level in the sight glass/brake fluid
reservoirs of control circuits remains constant de-
spite wear of the brake pads.
If the level drops below the MIN mark, this indicates
some other fault.
Front brake
•
Place the motorcycle on its centre stand.
•
Turn the handlebars fully to the left.
•
Check brake fluid level at sight glass.
Specified level
not below ......................................................... MIN
(top edge of the marking ring)
•
Correct the fluid level if necessary.
Brake fluid....................................................DOT 4
Rear brake
•
Place the motorcycle on its centre stand.
•
Remove case and right trim panel.
•
Check the brake fluid level.
Specified level
not below ......................................................... MIN
•
Correct the fluid level if necessary.
Brake fluid ...................................................DOT 4
Checking brake system for correct
operation and freedom from leaks;
repairing/replacing if necessary
(Inspection III)
•
Check all brake lines and their holders for dam-
age and correct positioning.
•
Wipe down all threaded unions on the brake lines
and check them.
•
Switch on the ignition.
L Note:
After switching on the ignition, always wait for the
BMW Integral ABS to complete its self-diagnosis.
Do not operate the brake lever until self-diagnosis
has completed.
d Warning:
When performing maintenance and repair work on
BMW Integral ABS, never pump quickly or
vigorously.
•
Apply firm pressure to the brake lever and brake
pedal and keep this pressure applied for a few
moments.
•
After this, inspect the brake lines for leaks.
d Warning:
Defective lines and threaded unions in the brake
system must always be replaced without delay.
R22000140
R22000150
To Next Page
Loading...
Need help?
General
