4-12
Confidential
2 IF YOU REPLACE THE HEAD/CARRIAGE UNIT
<Operations>
2.1 Update the head property data (Maintenance mode 68)
2.2 Perform ink supply purge (Maintenance mode 76)
2.3 Check head nozzles (Maintenance mode 09)
2.4 Adjust head inclination
2.5 Adjustment of vertical print lines/software correction for inclination/corrugation/ruled
lines (Maintenance mode 65)
2.6 Update paper feeding correction values (Maintenance mode 58)
2.7 Adjust margins in borderless printing (Maintenance mode 66)
2.8 Write head calibration data (Maintenance mode 02)
2.9 Check scanning and printing
2.10 Obtain machine information at the user site (Instruction to the end user)
<Requirements>
(1) USB cable (one piece)
(2) PC (Windows
®
XP or later)
Create a temporary folder in the C drive.
(3) Service setting tool (brusbsn.zip)
Make a copy of the service setting tool in the temporary folder in the C drive. Extract the
copied file and run it by double-clicking.
(4) Download utility (FILEDG32.EXE)
Make a copy of the download utility in the temporary folder in the C drive.
(5) Maintenance driver (MaintenanceDriver.zip), if not installed
Make a copy of the maintenance driver in the temporary folder in the C drive. Extract the
copied file and install it, referring to
APPENDIX 3. "INSTALLING THE MAINTENANCE
PRINTER DRIVER"
.
(6) USB flash memory or SD card
(7) Print data (Corrugate_BHS13.prn) for adjustment of vertical print lines/software correction
for inclination, corrugation and ruled lines.
(8) Print data for adjusting paper feeding correction values
For A4-sized paper: pfadj1_A4_BHS13.prn and pfadj2_A4_BHS13.prn,
For letter-sized paper: pfadj1_LTR_BHS13.prn and pfadj2_LTR_BHS13.prn
(9) Print data for adjusting margins in borderless printing
For A4-sized paper: mediaadj_A4_BHS13.prn
For letter-sized paper: mediaadj_LTR_BHS13.prn
(10) Print data for writing head calibration data
head_calib1_BHS13.prn
head_calib2_BHS13.prn
(11) ADF copy chart data (chart_BHS13.prn)
To Next Page
Loading...
Need help?
General
