Digi Connect IT 16 User Manual

Serial port Add a USB console port
Digi Connect IT® 16/48 User Guide
179
l A single IP address or host name.
l A network designation in CIDR notation, for example, 2001:db8::/48.
l any: No limit to IPv6 addresses that can access the ssh port.
Repeat this step to list additional IP addresses or networks.
n To limit access to hosts connected through a specified interface on the
Connect IT 16/48 device:
(config serial USB_port)> add service ssh acl interface end
value
(config serial USB_port)>
Where value is an interface defined on your device.
Display a list of available interfaces:
Use ... network interface ? to display interface information:
(config serial USB_port)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip Default IP
defaultlinklocal Default Link-local IP
eth1 ETH1
eth2 ETH2
loopback Loopback
sfp1 SFP1
sfp2 SFP2
wwan WWAN
(config serial USB_port)>
Repeat this step to list additional interfaces.
n To limit access based on firewall zones:
(config serial USB_port)> add service ssh acl zone end value
Where value is a firewall zone defined on your device, or the any keyword.
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config serial USB_port)> ... firewall zone ?
Zones: A list of groups of network interfaces that
can be referred to by packet
filtering rules and access control lists.
Additional Configuration

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English