Serial port Configure the serial port
Digi Connect IT® 16/48 User Guide
161
n Exclusive access: enabled
n Idle timeout: 15m
n Reversed mode: disabled
Note You can also configure the serial port by using Device Configuration > Serial. Changes made by
using either Device Configuration or Serial Configuration will be reflected in both.
To change the configuration to match the serial configuration of the device to which you want to
connect:
WebUI
1. Log into the Connect IT 16/48 WebUI as a user with Admin access.
2. On the menu, click System. Under Configuration, click Serial Configuration.
The Serial Configuration page is displayed.
n Use the Search ports field to limit the list of ports displayed on the page.
n Select the number of Ports per page that you want to display. Click the appropriate
number or click ALLto display all ports. You can also click Next or Back to display the
next or previous set of ports.
Note The number ports you can display is determined by the number of ports available
on the device.
3. Click on the port name to expand the port you want to configure.
The Settings section that display depend on the mode selected for the port. If Remote Access
is selected, all sections display. If Login or Power Management are selected, only the Serial
Settings section displays.
Note The serial port is enabled by default. To disable the serial port, toggle off Enable.
To Next Page
Loading...
Need help?
General