Digi Connect IT 16 User Manual

User authentication Authentication groups
Digi Connect IT® 16/48 User Guide
504
ii. Add a captive portal:
(config)> add auth group test acl portal portals end portal1
(config)>
7. (Optional) Configure Nagios monitoring:
(config)> auth group test acl nagios enable true
(config)>
8. (Optional) Enable users that belong to this group to access the Bluetooth scanning service:
(config)> auth group test acl bluetooth_scanner enable true
(config)>
9. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Delete an authentication group
By default, the Connect IT 16/48 device has two preconfigured authentication groups: admin and
serial. These groups cannot be deleted.
To delete an authentication group that you have created:
WebUI
1. Log into the Connect IT 16/48 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Authentication > Groups.
4. Click the menu icon (...) next to the group to be deleted and select Delete.

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English