Digi Connect IT 16 User Manual

Services Modbus gateway
Digi Connect IT® 16/48 User Guide
396
2. Use the show location geofence command at the system prompt:
> show location geofence
Geofence Status State Transitions Last Transition
------------- ------ ------ ----------- ---------------
test_geofence Up Inside 0
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Modbus gateway
The Connect IT 16/48 supports the ability to function as a Modbus gateway, to provide serial-to-
Ethernet connectivity to Programmable Logic Controllers (PLCs), Remote Terminal Units (RTUs), and
other industrial devices. MODBUS provides client/server communication between devices connected
on different types of buses and networks, and the Connect IT 16/48 gateway allows for
communication between buses and and networks that use the Modbus protocol.
This section contains the following topics:
Configure the Modbus gateway 397
Show Modbus gateway status and statistics 410

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English