Command line interface Access the command line interface
Digi Connect IT® 16/48 User Guide
697
Access the command line interface
You can access the Connect IT 16/48 command line interface using an SSH connection, a telnet
connection, or a serial connection. You can use an open-source terminal software, such as PuTTY or
TeraTerm, to access the device through one of these mechanisms.
You can also access the command line interface in the WebUI by using the Terminal, or the Digi
Remote Manager by using the Console.
To access the command line, your device must be configured to allow access, and you must log in as a
user who has been configured for the appropriate access. For further information about configuring
access to these services, see:
n Serial: Configure the serial port
n WebUI: Configure the web administration service
n SSH: Configure SSHaccess
n Telnet: Configure telnet access
Log in to the command line interface
Command line
1. Connect to the Connect IT 16/48 device by using a serial connection, SSH or telnet, or the
Terminal in the WebUI or the Console in the Digi Remote Manager. See Access the command
line interface for more information.
n For serial connections, the default configuration is:
l 115200 baud rate
l 8 data bits
l no parity
l 1 stop bit
l no flow control
n For SSHand telnetconnections, the default IP address of the device is192.168.2.1 on the
.
The device is also accessible at the default IP address of 192.168.210.1. However,
because this IP address does not use a DHCP server, to connect to this address you
must configure your local PC with an appropriate static IP address (for example,
192.168.210.2).
2. At the login prompt, enter the username and password of a user with Admin access:
login: admin
Password: **********
The default username is admin. The default unique password for your device is printed on the
device label.
3. Depending on the device configuration, you may be presented with another menu, for example:
Access selection menu:
To Next Page
Loading...
Need help?
General