Command line interface Display help for commands and parameters
Digi Connect IT® 16/48 User Guide
699
Display help for commands and parameters
The help command
When executed from the root command prompt, help displays information about autocomplete
operations, how to move the cursor on the Connect IT 16/48 command line, and other keyboard
shortcuts:
> help
Commands
-------------------------------------------------------------------------------
? Show commands help
<Tab> Tab completion, displays all valid commands to complete command,
if only one command is possible, it is used
<Space> Like tab except shortest prefix is used if command is valid
<Enter> Enter an input. If quoting then a new line is created instead. If
the input is invalid then characters will be deleted until a
prefix for a valid command is found.
Ctrl + A Move cursor to start of line
Ctrl + E Move cursor to end of line
Ctrl + W Delete word under cursor until start of line or [\',", ,\,/,.]
Ctrl + R If the current input is invalid then characters will be deleted
until a prefix for a valid command is found.
Ctrl + left Jump cursor left until start of line or [\',", ,\,/,.]
Ctrl + right Jump cursor right until start of line or [\',", ,\,/,.]
>
The question mark (?) command
When executed from the root command prompt, ? displays available commands:
> ?
Commands
-------------------------------------------------------------------------------
config View and modify the configuration
exit Exit the CLI
analyzer Analyzer commands.
cp Copy a file or directory.
help Show CLI editing and navigation commands.
ls List a directory.
mkdir Create a directory.
modem Modem commands.
more View a file.
mv Move a file or directory.
ping Ping a host.
reboot Reboot the system.
rm Remove a file or directory.
scp Copy a file or directory over SSH.
show Show instance statistics.
system System commands.
traceroute Print the route packets trace to network host.
To Next Page
Loading...
Need help?
General