Digi Connect IT 16 User Manual

Virtual Private Networks (VPN) OpenVPN
Digi Connect IT® 16/48 User Guide
286
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
Current value:
(config vpn openvpn client name)>
5. (Optional) Set the route metric for the OpenVPN server. If multiple active routes match a
destination, the route with the lowest metric will be used.
(config vpn openvpn client name)> metric value
(config vpn openvpn client name)>
where value is an interger between 0 and 65535. The default is 0.
6. (Optional) Set the login credentials as configured on the OpenVPN server:
(config vpn openvpn client name)> username value
(config vpn openvpn client name)> password value
(config vpn openvpn client name)>
7. Paste the content of the client.ovpn file into the value of the config_file parameter:
(config vpn openvpn client name)> config_file value
(config vpn openvpn client name)>
8. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure an OpenVPN client without using an .ovpn file
Required configuration items
n Enable the OpenVPN client.
The OpenVPN client is enabled by default.
n The mode used by the OpenVPN server, either routing (TUN), or bridging (TAP).
n The firewall zone to be used by the OpenVPN client.
n The IP address of the OpenVPN server.

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English