Digi Connect IT 16 User Manual

Applications Run a Python application at the shell prompt
Digi Connect IT® 16/48 User Guide
448
n Remove the script from the device and add it again.
n Make a change to the script.
n Disable once.
10. Sandbox is enabled by default. This option protects the script from accidentally destroying the
system it is running on.
(config system schedule script 0)> sandbox true
(config system schedule script 0)>
11. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Run a Python application at the shell prompt
Python applications can be run from a file at the shell prompt. The Python application will run until it
completes, displaying output and prompting for additional user input if needed. To interrupt the
application, enter CTRL-C.
Note Python applications cannot be run from the Admin CLI. You must access the device shell in order
to run Python applications from the command line. See Authentication groups for information about
configuring authentication groups that include shell access.
1. Upload the Python application to the Connect IT 16/48 device:
WebUI
a. Log into the Connect IT 16/48 WebUI as a user with Admin access.
b. On the menu, click System. Under Administration, click File System.
The File System page appears.

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English