System administration Erase device configuration and reset to factory defaults
Digi Connect IT® 16/48 User Guide
599
Command line
1. Log into the Connect IT 16/48 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the reboot time:
(config>> system schedule reboot_time time
(config)>
where time is the time of the day that the device should reboot, using the format HH:MM. For
example, the set the device to reboot at two in the morning every day:
(config>> system schedule reboot_time 02:00
(config)>
If a value is set for reboot_time but the device is unable to synchronize its time with an NTP
server, the device will reboot after it has been up for 24 hours. See System time for information
about configuring NTP servers.
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Erase device configuration and reset to factory defaults
You can erase the device configuration in the WebUI, at the command line, or by using the Reset
button on the device. Erasing the device configuration performs the following actions:
n Clears all configuration settings. When the device restarts, it uses the factory default
configuration.
n Deletes all user files.
n Clears event and system log files.
Additionally, if the Reset button is used to erase the configuration, pressing the Reset button a second
time immediately after the device has rebooted:
To Next Page
Loading...
Need help?
General