System administration Schedule system maintenance tasks
Digi Connect IT® 16/48 User Guide
610
Schedule system maintenance tasks
You can configure tasks and custom scripts to be run during a specified maintenance window.
Required configuration items
n The time that the system maintenance tasks will start.
n The duration window during which the system maintenance tasks can run.
n The frequency (either daily or weekly) that the tasks will run.
n The tasks to be performed. Options are:
l Modem firmware update.
l Configuration check.
Additional configuration items
n Custom scripts that should be run as part of the configuration check.
WebUI
1. Log into the Connect IT 16/48 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click System > Scheduled tasks > System maintenance.
4. For Start time, type the time of day that the maintenance window should start, using the
syntax HH:MM. If Start time is not set, maintenance tasks are not scheduled and will not be
run.
The behavior of Start time varies depending on the setting of Duration window, which is
configured in the next step.
n If Duration window is set to Immediately, all scheduled tasks will begin at the exact
time specified in Start time.
To Next Page
Loading...
Need help?
General