Diagnostics Analyze network traffic
Digi Connect IT® 16/48 User Guide
673
Analyze network traffic
The Connect IT 16/48 device includes a network analyzer tool that captures data traffic on any
interface and decodes the captured data traffic for diagnostics. You can capture data traffic on
multiple interfaces at the same time and define capture filters to reduce the captured data. You can
capture up to 10 MB of data traffic in two 5 MB files per interface.
To perform a more detailed analysis, you can download the captured data traffic from the device and
view it using a third-party application.
Note Data traffic is captured to RAM and the captured data is lost when the device reboots unless you
save the data to a file. See Save captured data traffic to a file.
This section contains the following topics:
Configure packet capture for the network analyzer 674
Example filters for capturing data traffic 678
Capture packets from the command line 679
Stop capturing packets 680
Show captured traffic data 680
Save captured data traffic to a file 682
Download captured data to your PC 683
Clear captured data 684
To Next Page
Loading...
Need help?
General